¶ Camera Replacement
This guide explains how to replace the camera module on your laser machine. It provides step-by-step instructions for removing the old camera, installing a new module, and completing the required manual calibration.
Proper installation ensures accurate positioning, visual alignment, and engraving preview performance.
¶ Required Tools
- 1.5mm and 2mm Allen wrench
- New camera module
¶ Operation Guide
¶ Remove Camera
Open the front door cover and loosen the fixing screws on both sides of the camera cover, but there is no need to remove the screws.
Remove the camera cover.
Unplug the signal cable of the camera, and then unscrew the 4 screws fixing the camera to take out the camera.
¶ Installation of Camera
Fix the brand new camera on the door cover and connect the signal cable
Reinstall the camera cover.
NOTE:
After completing the camera replacement, you will need to perform the camera calibration manually. The calibration file in the USB flash drive that came with the machine will no longer work.
Important Reminder:
If these steps do not resolve the issue, please submit a support ticket. A technician will then be able to conduct a more in-depth diagnosis.